I have a 1976 42' convertible. I'm trying to trace the wiring back from my galley maid pump. Is there an electrical drawing available? Does anyone know where these two wires from the pump begin?

OK, I just hopped of a buddy's redone 42 Bertram & found a new entry that goes right to the top of my "must have" list: Single lever controls. Although his are electric and came with his new Volvo power, I know there are other electric & cable types to replace my OEM dual Morse controls. While...

On my 37' I have decided to combine the 1" A/C thru hull & the 1" generator thru hull into one. The one 1.5" will feed a small water closet, to be mounted just below the waterline, which will feed the 1" line to the generator (8.5 KW Onan) and A/C pumps. In the process, I have discovered my...

I have removed the salon draperies from my 1979 43DC. They are salmon colored, pleated draperies and should fit a 1970 to 1984 model 43DC. If you're interested ... email me at eze2bme@aol.com ... all you pay is shipping.

My port engine has developed a nasty habit of stalling when shifting the transmission. Occurs the worst possible times - like when maneuvering into a slip with a large group of onlookers. What's puzzling is that it only happens after a long run and the engines are hot. Idle is set at 550 rpm...

Wed AM I am craning my engines out and I will be prepping the bildge and inspecting the engine mounts. My mounts are original as far as I know. The bottom part of the mount, which is aluminum and attached to the stringers, is corroded but can be cleaned up. The upper part of the mount, which is...

I have single lever Morse controls aboard. One still operates smoothly, the other is pretty sticky. Anyone have experience with greasing? Is it necessary to completely remove/dissamble to do the job, or can it be done from under the flybridge? I also queried Teleflex Morse but would still...

The groco eb style head on my 32 sportfish refuses to work properly even after replacing the piping to the holding tank, rebuilding the pump, and doing every other thing I can think of to solve the problem. The head pump runs but will not evacuate any more than some liquid with what seems to me to...

I just inserted a project on the new project tracking list. Has anyone else tried it? Depending how it works, it may be a great tool. Thanks Ben and Tina "Size Matters"

I noticed that when running, the a/c on my 53 MY seems to be loosing some efficiency... these days, instead of maintaining 75/76 deg in the salon (on the digital control) the system can't bring it down below78/79... I'm guessing it has to do with the amount of heat building up in the engine room...