Without knowing the hx of your boats bottom, other than there isn’t any existing blisters, if you are hauling to paint the bottom would you apply barrier coat?

Need help in finding a way to get to the backside of TV service inlet , on a 1986 43My, to replace the existing TV cable and run it to the starboard front portion the the salon, Thanks Werner Schoenknecht MIRAGE

Just found a Freon leak coming from behind starboard salon wall that feeds my starboard rear evaporator has anyone removed the panels if so how 1978 53 motor yacht Tracy

1) what level should I fill the cooling water reservoir tank up to? I have given different answers. Fill to the top or fill to about an inch (1/2 of index finger) to the top?2) my delivery captain told me to fill the reservoir with water. Shouldn’t I fill with 50/50 water and antifreeze? Or maybe...

Just wanted to bring everyone up to date on my over heating problem. I changed the thermostat this weekend and checked with the temp gun at the housing which holds the thermostat and it checked out at 168 to 170 deg. It was a 170 deg. thermostat I replaced. Checked the starboard engine and was...

Have a 1965 41DC with 426 Chrysler Wedges. I need to replace a tach (SB tach doesn't go over 2000RPM) , 2 fuel gauges (1965 model gauge not compatible with new tanks), and a water temp (P side doesn't work... ) I would hate to see portion of the gauges to be original Hatt gauges, and the rest...

Hello all, currently looking at a 55' Hatteras Convertible with the motors above(870hp). A little over 3,000 hours on them and just wondering from experience what to look for...pro's cons. I understand they are more than likely at the end of their rope and needing a rebuild soon, however from my...

I recently purchased and used a Dremel 1 & 1/2" Dia Metal Cutoff tool and I hereby report it worked great! It is a professionally packaged kit to use with an existing 10k rpm Dremel (if you have one), so as they say, the kit is sold separately from the Dremel. I had new to us home multi-head...

And now the big Kahoona... Last week, the day before haul out, I checked the anti freeze and it was good to about +7F. Being that it was low, I added 3 gallons straight on each and went for a 45 minute ride before the lift to mix it up. I checked it today and its good for -7F. Since I am going...