Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1001 of 1106 FirstFirst ... 501 901 951 991 999 1000 1001 1002 1003 1011 1051 1101 ... LastLast
Threads 20001 to 20020 of 22112

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Coolant aditive

    Hello all . Flushing out my 8-71s and like to change to distilled water with a corrosion additive, is napa kool #fil4056 ok to use thanks mike

    Started by Mike in S Fla‎, 12-05-2014 08:22 PM
    • Replies: 0
    • Views: 1,063
    Mike in S Fla
    12-05-2014, 08:22 PM Go to last post

  2. 1980 53 MY Salon AC drains to where?

    My AC in the salon, the one next to the aft deck doors has a plugged drain line. I'm trying to figure out where it drain to. I looked under the aft cabin bed and it doesn't appear to be there. Does anyone know where it drains out to? My entire downstairs floor is carpeted. I'm guessing there...

    Started by Bob Quinn‎, 07-03-2023 12:10 PM
    3 Pages •
    1 2 3
    • Replies: 20
    • Views: 1,062
    Bob Quinn
    07-28-2023, 01:08 PM Go to last post

  3. Ignition fuse failure

    So I am returning from Cuttyhunk Island, just entering the canal at about 2200 and my stbd. engine shuts down 3208 TA aboard my 1991 40 Motoryacht. All gauges and all fine untill then. Went to restart no power. Tested batteries all fine. Found 20 amp Ignition fuse mounted on fwd. er bulkhead blown....

    Started by sea trial‎, 08-10-2009 12:39 PM
    • Replies: 0
    • Views: 1,062
    sea trial
    08-10-2009, 12:39 PM Go to last post

  4. Vacuflush vacuum switch adjustment

    My forward head would take a long time to pump down due to over pumping. I adjusted that switch but now not enough vacuum and it looses vacuum and cycles now and then. Did not do this with too much vacuum. The guest head pumps to what seems to be correct vacuum but it has always lost vacuum (at...

    Started by madhatter1‎, 09-07-2020 09:27 AM
    • Replies: 4
    • Views: 1,062
    Pascal
    09-07-2020, 08:29 PM Go to last post

  5. 2006 Rendezvous a Success

    The Hatteras 1510 club held the annual Rendezvous this past weekend in Portsmouth,Va. A total of 10 boats attended and about as many drive in/fly in members attended as well. After dealing with some rough water and some rain, the weekend weather was great. For those of you that are either not...

    Started by wndsr‎, 09-12-2006 07:12 PM
    • Replies: 0
    • Views: 1,062
    wndsr
    09-12-2006, 07:12 PM Go to last post

  6. Installing Converter / House battery system 68 Hatteras

    Battery Converter. 1968 Hatteras. Installing a Progressive Dynamics Marine Converter and setting up a separate house battery bank. Currently the boats house DC system runs off the engine batteries. Question. Has anyone every install converter on an old system? Would you bypass the battery ...

    Started by Tombo‎, 03-18-2019 06:58 PM
    2 Attachment(s)
    • Replies: 2
    • Views: 1,062
    Pascal
    03-19-2019, 11:36 AM Go to last post

  7. Rusty Simpson Lawrence plow anchor

    Cleanning it up. What's next? Paint with zinc paint? Prime?

    Started by tomrealest‎, 03-19-2019 12:21 AM
    • Replies: 1
    • Views: 1,062
    Scarlett
    03-19-2019, 11:26 AM Go to last post

  8. 43c 1981 Rubrail Issue

    Looking to purchase but the boat has some issues on the starboard rubrail. Appears to be some slight separation at the joint? Is this to be expected? Can anyone share how these joints were assembled at the factory?Thanks.

    Started by MiBuckeye‎, 08-16-2019 08:37 PM
    • Replies: 2
    • Views: 1,061
    MiBuckeye
    08-17-2019, 09:15 AM Go to last post

  9. My Swim Platform repair project.

    Much has been written about swim platform repairs but in my repair project, I found a bit of over engineering in the transom While hauled out to repair my trim tabs, I found the old bronze swim platform brackets had cracks right at the 90 degree welded joints. See the black circles. I...

    Started by jrbrein‎, 10-11-2020 03:02 PM
    8 Attachment(s)
    • Replies: 5
    • Views: 1,061
    racclarkson@gmail.com
    10-12-2020, 06:29 AM Go to last post

  10. picture posting limit...

    I see that I have maxed out my allowance for posting pics. If I go to manage attachements and select any/all of them I assume they are removed from whichever posts they are in, right? I guess the only way to deal with it is to eliminate all pics prior to say, a month ago. Is there any other...

    Started by MikeP‎, 07-09-2006 06:21 PM
    • Replies: 0
    • Views: 1,061
    MikeP
    07-09-2006, 06:21 PM Go to last post

  11. Paint for the thermal blankets

    What type of paint should we use on the thermal blankets. I need to touch up mine.

    Started by questover‎, 08-11-2009 01:40 PM
    • Replies: 0
    • Views: 1,061
    questover
    08-11-2009, 01:40 PM Go to last post

  12. Cranking Amps Required For 12V71

    Curious: What is the cranking amps (or watts) required for a 12V71 32 volt starter motor please? At the moment we have 4 x 180ah deep cycle golf cart batteries in series to start each motor. But they do not give CCA.

    Started by scottinsydney‎, 08-09-2022 05:10 PM
    2 Pages •
    1 2
    • Replies: 12
    • Views: 1,061
    Captain Ralph
    08-10-2022, 10:05 PM Go to last post

  13. 48 Motoryacht Series II - Davit location

    We have just acquired a 1990 48 Motoryacht which came with an unistalled davit. I would be interested in where other owners have located their davits before we start cutting holes. Steve Maehr Oasis

    Started by smaehr‎, 08-16-2009 11:04 AM
    • Replies: 0
    • Views: 1,061
    smaehr
    08-16-2009, 11:04 AM Go to last post

  14. 42 Conv w/671N - Performance?

    Can anyone comment on the performance to be expected from a 1970's 42 Conv. with 671N's? In reading the comments about the 43DC with 671N's, I'm worried that the 42Conv may just be a poor performer - it would be hard to have a conv and not be able to get it on a plane/ Many thanks, geo.

    Started by st.tully‎, 10-13-2006 09:41 AM
    • Replies: 1
    • Views: 1,061
    Genesis
    10-13-2006, 09:59 AM Go to last post

  15. Auto Pilot Swaying

    Not with the boat right now but I think I have an older auto pilot 6000. I have been meaning to ask, what would be causing my auto pilot to sway about 5 to 10 degrees when activated. Some days it runs a lot more true than others? Checked the pressure in steering and made sure I have 30 lbs of...

    Started by captbuddy‎, 07-21-2013 11:56 AM
    • Replies: 2
    • Views: 1,061
    captbuddy
    07-21-2013, 10:04 PM Go to last post

  16. Question Hauling a1972 36 C

    I am in the process of purchasing a 36 C Hatteras I need to truck it from Maryland to Washington state. However getting the accurate dimensions from the keel to the top of the helm is proving to be a major ordeal. Does anyone know the dimensions for transport or know a transport company who has...

    Started by RandyRampage‎, 09-15-2020 10:03 AM
    hauling, height dimensions, transporting
    • Replies: 3
    • Views: 1,061
    Freeebird
    09-15-2020, 12:31 PM Go to last post

  17. Crusair AC problem

    Just started a summer cruise and have a problem with one of my AC units. The SMX display, which is the updated version, indicates that the AC thinks it is 0 degrees in the galley. Because of that, the unit will not go into the cool mode. I have tried a master reset, and to adjust up through...

    Started by JLR‎, 07-25-2015 12:21 PM
    • Replies: 1
    • Views: 1,060
    JLR
    07-25-2015, 01:33 PM Go to last post

  18. Old Marine AC help needed

    Guys - I have an old Eastern Air 17000 BTU AC in my 34. The air ran fine until last year when the compressor quit turning itself on and off and just ran non stop when teh unit was turned on. The AC guys have informed me that the compressor thermostat has gone bad. Its a Ranco unit, but there are...

    Started by poseidon‎, 10-01-2009 01:05 PM
    3 Attachment(s)
    • Replies: 0
    • Views: 1,060
    poseidon
    10-01-2009, 01:05 PM Go to last post

  19. Cummins 6CTAs oil filter location

    Time for the first oil change on my C-series after repower. Figured it would be easy since I have a brand new oil change system, and pretty good access around the engines. well... that would have been the case if the geniuses over at Cummins had not decided to mount the coolant filter right in...

    Started by Pascal‎, 10-01-2020 03:47 PM
    1 Attachment(s)
    • Replies: 6
    • Views: 1,060
    Finnley
    10-03-2020, 10:34 PM Go to last post

  20. Replacing Front Window on 53MY

    I have a spider crack through my front, portside window (1 of 3 windows on front), and would like to replace. Is is as simple as removing the rubberish weather strip around outside of window (from outdoors) (grey colored strip) and then will the window just pop out if pressure applied from...

    Started by rangerscott275‎, 05-16-2008 02:49 PM
    • Replies: 1
    • Views: 1,060
    rangerscott275
    05-16-2008, 02:53 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 354 users browsing this forum. (3 members & 351 guests)

  1. Avenger
  2. Boatsb
  3. pmacFL

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules