Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 1104 1 2 3 11 51 101 501 1001 ... LastLast
Threads 1 to 20 of 22078

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 18,117
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    3639 Pages
    1 2 3 ... 3639
    • Replies: 36,384
    • Views: 4,014,917
    Yesterday, 10:45 PM Go to last post
  2. Ok I give up what is it ?

    Subscribing to the theory that everything is done for a reason…what are these posts sticking out of the top of the shower doors. I assume these are original all three baths have the same doors . I’m guessing it had some kind of mechanism or latch to keep the doors from swinging closed when they’re...

    Started by IOLANI‎, Yesterday 12:43 PM
    • Replies: 6
    • Views: 157
    Yesterday, 09:16 PM Go to last post
  3. Interior sun shade material for inside of isenglass

    Looking for ways to keep out sun out of upper helm and aft deck during hot summer months. Any ideas for temporary sun block on interior isenglass?

    Started by sunsetacres1318‎, 04-21-2024 11:02 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 179
    Yesterday, 07:25 PM Go to last post
  4. A/C Raw water pump size

    Anybody know what the factory raw water a/c cooling pump flow rating is? I have a shipyard telling me that the current units are undersized and that I should increase the flow rate. I have a 1988 67’ CPMY. Thank you

    Started by Kquaine‎, Yesterday 01:49 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 232
    Yesterday, 05:56 PM Go to last post
  5. Onan generator starter

    Struggling a little bit. I have an Onan 15.0 marine genset onboard my 1994 48’ Hatteras cpmy. The starter for the genset is having trouble engaging the bendix. I haven’t torn it apart but completely expect that the gear is worn. Hopefully not the flywheel. Does anyone know a source for a starter...

    Started by Phasma2128‎, 04-21-2024 09:53 AM
    • Replies: 5
    • Views: 151
    Yesterday, 02:26 PM Go to last post
  6. Pulled the Onan Generator // put this off toooo long

    It rare that I turn off my cell phone but I did and missed the txt at 8AM that they are pulling the generator out today (a week early). Then at Noon I got this wonderful photo. I put this job off because I could never find someone who wanted to deal with that removal, and it was too big for...

    Started by metama‎, 04-20-2024 01:03 PM
    • Replies: 7
    • Views: 321
    Yesterday, 12:31 PM Go to last post
  7. Detroit diesel closed loop cooling questions

    1) what level should I fill the cooling water reservoir tank up to? I have given different answers. Fill to the top or fill to about an inch (1/2 of index finger) to the top?2) my delivery captain told me to fill the reservoir with water. Shouldn’t I fill with 50/50 water and antifreeze? Or maybe...

    Started by Kquaine‎, Yesterday 02:11 AM
    • Replies: 4
    • Views: 144
    Yesterday, 11:53 AM Go to last post
  8. Engine Room Paint

    Have a 97 Hatteras 50 Sportdeck with DD 6V92. Looking to clean up engine room and do some painting of engines. Any recommendations on what paint to use? Engines are currently white and want to use same color.

    Started by sunsetacres1318‎, 04-21-2024 10:59 AM
    • Replies: 5
    • Views: 243
    Yesterday, 08:36 AM Go to last post
  9. Jabsco raw water pumps

    A couple questions for the forum. Has anyone replaced the cover plate’s slotted style screws for studs ? Seems a better method overall having studs where a nut is easily torqued to spec and installing gasket, cover etc. any reason not to install silicon bronze studs? Spline lubricant. ...

    Started by bostonhatteras‎, 04-21-2024 09:15 AM
    • Replies: 9
    • Views: 224
    Yesterday, 06:38 AM Go to last post
  10. Hynautic vented or non vented?

    I'm working on installing a new Garmin AP w/ Smart Pump. Reading the "hydraulic considerations" page in the install manual and it states: "This pump must not be installed with a steering system that has an unvented reservoir, because it will damagethe pump. Before installing the pump, you...

    Started by RyanB‎, 04-19-2024 04:18 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 515
    04-21-2024, 06:48 PM Go to last post
  11. No good deed goes unpunished

    Getting ready for our trips I figured I’d change the generator pump out for a new one I bought a year or two ago so we start out fresh. Start up yesterday to test and all is good. Arrive at anchorage today and I noticed light steam from exhaust. And not enough water. I have the original pump ready...

    Started by madhatter1‎, 04-19-2024 12:50 PM
    • Replies: 9
    • Views: 370
    04-21-2024, 06:18 PM Go to last post
  12. Hard wall exhaust hose or silicone

    Time to replace these short sections of hose on the raw water inlet pipe. Hard wall will be much more supportive but silicone will be easier to work with if I need to remove the pipe…like for impeller replacement, currently pia . Six of one, half dozen of the other or is one choice a clear...

    Started by bostonhatteras‎, 04-21-2024 12:03 PM
    • Replies: 1
    • Views: 97
    04-21-2024, 02:46 PM Go to last post
  13. Maxwell windlass install

    I’ll break from my laziness on posting pics and give a decent few on this project. First pic comes with a question. The photo shows the 3/4” windlass lifting block and the 1.5” chain stopper lifting block. This is pretty much all the space I have within the rode locker and the rear most bolt of...

    Started by bostonhatteras‎, 11-16-2023 05:38 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 673
    04-21-2024, 12:36 PM Go to last post
  14. Delo 100 online?

    Anybody buying Delo 100 through an online retailer? My local DD is crazy priced for the old delvac at $45 per gallon. Oriellys auto parts at $25 seems the best game in town for gallons but I'd prefer 5 gallon pails. BTW just fueled from a truck with offroad at 3.77 gallon, not bad.

    Started by bostonhatteras‎, 04-20-2024 08:14 AM
    • Replies: 3
    • Views: 207
    04-21-2024, 10:46 AM Go to last post
  15. Mask Yea or nay

    I painted the vertical supports between forward glass, corners to side glass, and between side fixed panel and sliders to update the look a bit. The bright white, to me, was too much contrast between the grey tint on side glass and even the clear glass of the forward panels. Too modern for an...

    Started by bostonhatteras‎, 04-18-2024 11:15 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 635
    04-19-2024, 04:26 PM Go to last post
  16. Making an anchoring bridle

    Had a long chain on my 34. Got rid of it due to heavy snap in seas. Formed an opinion that I don't like much chain. Have had great results with only 20' of chain on both the 34 and now the 46. Think the success is due to setting properly, stern anchor when needed, or just simply paying attention on...

    Started by madhatter1‎, 04-18-2024 10:19 PM
    • Replies: 7
    • Views: 388
    04-19-2024, 04:23 PM Go to last post
  17. New Video is up

    I know a few of you watch my videos now, but my posting schedule is not regular, so I thought I'd let you know a new video went live tonight. https://youtu.be/BXZ78Yizymg Thanks for watching and for all the support and great info and friendship!

    Started by Hat4Shay‎, 04-18-2024 09:49 PM
    • Replies: 0
    • Views: 194
    04-18-2024, 09:49 PM Go to last post
  18. New Flooring in Aft Deck - Marine Mat

    Started by JD5652‎, 04-17-2024 04:28 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 980
    04-18-2024, 01:24 PM Go to last post
  19. Moving HOF gallery pics to a post

    How do I move photos I've uploaded to HOF gallery to a post? I don't see any means of doing this.

    Started by bostonhatteras‎, 04-18-2024 10:29 AM
    • Replies: 3
    • Views: 212
    04-18-2024, 11:45 AM Go to last post
  20. windscreen wiper arms

    My '71 convertible has a lower station, so it has wipers to the left and right panes of the triple windshield. 99+% of the time there is a fabric cover over the windows, to control how how it gets in there and also to keep the windows from leaking when running the boat. The other day I found that...

    Started by jim rosenthal‎, 04-17-2024 07:30 PM
    • Replies: 2
    • Views: 366
    04-18-2024, 10:38 AM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 147 users browsing this forum. (0 members & 147 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts