Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 890 1 2 3 11 51 101 501 ... LastLast
Threads 1 to 20 of 17786

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 13,389
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Weather boards replacement

    The entire starboard side weather boards, railing and stanchions from the PH Door to the stern were wiped out during Irma last year the rest was in ok shape but i never really liked how flimsy it felt and all the seams, screws, etc.. So... i decided to do it in fixed fiberglass. Been kicking...

    Started by Pascal‎, Yesterday 08:29 PM
    • Replies: 4
    • Views: 52
    Yesterday, 11:28 PM Go to last post
  2. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    162 Pages
    1 2 3 ... 162
    • Replies: 1,613
    • Views: 46,834
    Yesterday, 09:50 PM Go to last post
  3. Generator Replacement / Galley Hatch question

    My next project is going to be to replace the original Kohler (Perkins) generator in my 1983 53 ED MY. I know this has been discussed in some old threads but I have a couple of 'simple' questions: 1) I'm a fan of Northern Lights (20 KW) from other boats I've owned. Is there anything better...

    Started by JonHupp‎, 07-19-2018 07:19 PM
    • Replies: 7
    • Views: 121
    Yesterday, 08:14 PM Go to last post
  4. Anyone Using AGM Batteries In Their 32 Volt System?

    Just curious. Anyone using AGM batteries in their 32 volt system? At the start of this season we wound up with three bad 8 volt batteries (Deka 819), mostly due to the LaMarche "battery cooker" and decided to replace both the charger which was original to the boat and and all the batteries since...

    Started by miboatnutz‎, 07-19-2018 07:36 AM
    • Replies: 8
    • Views: 168
    Yesterday, 02:33 PM Go to last post
  5. Overpropped

    My 1986 Hatteras sedan with 454 crusaders Gas engines. Best I can get is 3000 rpmsAnd 13.5 kts..Motors runs smooth,start good etc..Iíve change all filters, check carbs,Compression good..Have trim tabs, boat will ďalmostĒ planeOff. What size prop should I have for this boat ?Right now I have 26x23.

    Started by Robs‎, 07-18-2018 06:45 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 328
    Yesterday, 10:53 AM Go to last post
  6. New lower and upper helm design

    I ended up redoing both helm stations as the Cummins instrument pods didnt fit well. I never liked the .ower helm which was too flat anyway. Also it weighted probably close to 250lbs :) and took another foot of space which makes a difference as i now have the galley up. There is very little...

    Started by Pascal‎, 07-19-2018 04:15 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 196
    Yesterday, 10:51 AM Go to last post
  7. Laminating afromosia veneer

    What have you used to glue veneer to a plywood substrate? Is there a particular brand that excels? Thanks!

    Started by johnjen50‎, Yesterday 07:36 AM
    • Replies: 5
    • Views: 68
    Yesterday, 09:59 AM Go to last post
  8. Fiberglass Help

    Hey everyone we have encountered something I have not seen, this is in one of the staterooms, after removing some of the headliner and wall coverings we found this discoloration in the fiberglass. My fiberglass guy says itís the layers becoming separated, they feel not as solid when sounded with a...

    Started by Texastailboard‎, 07-16-2018 12:25 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 447
    07-19-2018, 11:17 PM Go to last post
  9. Can I run a 120v generator to the 120 side of my 50 hatteras?

    My cummins onan generator is using oil at an alarming rate and I want to wait till the off season to replace it. I have a 2000 watt inverter generator but it's a 120v. Is there a way to run this generator just to power my battery charger, and 120v appliances? I'm not sure how that works with the...

    Started by Adembins‎, 07-18-2018 02:22 PM
    • Replies: 7
    • Views: 159
    07-19-2018, 08:55 PM Go to last post
  10. We have a bad transformer - recommendations?

    What recommendations are out there to replace the transformer/booster? 53' ED 50 amp - TIA!!

    Started by madhat53‎, 07-17-2018 09:52 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 292
    07-19-2018, 08:21 PM Go to last post
  11. Battery/Charging Problem

    The front battery on my port side continues to run hot and use water. On my 74, everything is 24 volts. The port side starts the port engine and is the house bank. The charger appears to be overcharging just that one front battery. I have replaced that battery twice in the last week and she still...

    Started by JLR‎, 07-03-2018 03:26 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 593
    07-19-2018, 12:47 PM Go to last post
  12. AC Raw Water Strainer Completely Fouled with Pea Sized Oysterss

    Yesterday, when I noticed my AC discharge water flow suddenly went to a trickle and ambient temp to air discharge dropped to 8 degrees F, I proceeded to pull the strainer for a periodic clean out. What I found was shocking. Usually when I check strainers, I find a few shells, bits of seaweed,...

    Started by Passages‎, 07-16-2018 12:52 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 361
    07-19-2018, 11:18 AM Go to last post
  13. Laundry Center

    Have a stacked Frigidaire Laundry Center. Pulled trim and panels off. Have access to the front. Motor just buzzes and won't agitate, spin, or drain. Anyone troubleshoot these units? Book says its 196lbs so not looking forward to getting it out. Might have to do what Scott suggest with a...

    Started by Chasemmc‎, 07-18-2018 06:16 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 156
    07-19-2018, 10:34 AM Go to last post
  14. Wilcox seabrace stabilizers

    Hi all, I have scoured the Internet trying to find a cross reference part number for seabrace servo motors. It is my understanding that they are Mercedes windshield wiper motors. I can't seem to find out any more information. Does anyone have a part number? Or a model number of the car that The...

    Started by Griffweegus‎, 03-07-2017 01:09 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,028
    07-19-2018, 09:00 AM Go to last post
  15. Awlwood finishing

    Over the years I've owned my 36 convertible, we've removed most of the teak trim that the boat came with. If you look at the brochure photos, there was quite a bit of exterior teak on the aft bulkhead, mostly gone now. All the ladder treads were also teak, now replaced with stainless. What is left...

    Started by jim rosenthal‎, 07-08-2018 10:41 AM
    3 Pages
    1 2 3
    • Replies: 24
    • Views: 687
    07-19-2018, 12:16 AM Go to last post
  16. Hatteras pinstripes decals

    Good day, Please assist with some recommendations i have the 1977 Hatteras Convertible boat which i busy renovating. I need advise on the pinstripes just above the antifouling.Which will be best suitable for my boat:1. Carbon fibre vinyl double or single pinstripes in black?2. Vinyl double or...

    Started by Petri Heil‎, 07-18-2018 11:55 PM
    • Replies: 0
    • Views: 52
    07-18-2018, 11:55 PM Go to last post
  17. Couple Pics of the 'ol gal

    Things are starting to come together nicely! Heading out to watch the Blue Angels Fly!

    Started by rustybucket‎, 07-18-2018 08:45 AM
    3 Pages
    1 2 3
    • Replies: 24
    • Views: 446
    07-18-2018, 09:11 PM Go to last post
  18. VHF antenna extension painting

    The antenna extension has no more exterior coating and the fiberglass is exposed. I'm wondering what to paint it with vs a new $300+ replacement.

    Started by MadHatter53‎, 07-14-2018 02:20 PM
    • Replies: 6
    • Views: 200
    07-18-2018, 06:46 PM Go to last post
  19. 8v92 Antifreeze Flush

    Looked at past threads and didn't find what I need to start this project. Had a local mechanic hired, but he crapped out, so I thought I would take a run at it. It would be better for me to learn how anyway. I need to flush the antifreeze out of the 8v92ti's. Got brown rust crust at the...

    Started by Chasemmc‎, 07-18-2018 06:10 PM
    • Replies: 1
    • Views: 57
    07-18-2018, 06:43 PM Go to last post
  20. Acme Transformer and Boost Switch

    I have an Acme Transformer on the Port Wall as well as a Low Boost/Off /High Boost Selector switch in Panel.. How Does this this work- on Low Boost at my dock the transformer seems really hot- If I turn the boost switch- it shuts off the panel? 1971 53 My with upgraded Outback inverter-- do I need...

    Started by caryboat‎, 08-05-2013 11:52 PM
    • Replies: 6
    • Views: 621
    07-18-2018, 06:01 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 106 users browsing this forum. (1 members & 105 guests)

  1. SEVEN

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts