Here you go

I need to fix a leak into the salon. Looking for some guidance on this, as I am a new owner of a 1979 53' Hatteras YF. At the end of last year, it was showing a leak into the salon from the bridge. Issue may have started from the bridge not being shrinkwrapped in previous years, which allowed heavy...

Struggling a little bit. I have an Onan 15.0 marine genset onboard my 1994 48’ Hatteras cpmy. The starter for the genset is having trouble engaging the bendix. I haven’t torn it apart but completely expect that the gear is worn. Hopefully not the flywheel. Does anyone know a source for a starter...

Looking for ways to keep out sun out of upper helm and aft deck during hot summer months. Any ideas for temporary sun block on interior isenglass?

It rare that I turn off my cell phone but I did and missed the txt at 8AM that they are pulling the generator out today (a week early). Then at Noon I got this wonderful photo. I put this job off because I could never find someone who wanted to deal with that removal, and it was too big for...

A couple questions for the forum. Has anyone replaced the cover plate’s slotted style screws for studs ? Seems a better method overall having studs where a nut is easily torqued to spec and installing gasket, cover etc. any reason not to install silicon bronze studs? Spline lubricant. ...

I’ll break from my laziness on posting pics and give a decent few on this project. First pic comes with a question. The photo shows the 3/4” windlass lifting block and the 1.5” chain stopper lifting block. This is pretty much all the space I have within the rode locker and the rear most bolt of...

I painted the vertical supports between forward glass, corners to side glass, and between side fixed panel and sliders to update the look a bit. The bright white, to me, was too much contrast between the grey tint on side glass and even the clear glass of the forward panels. Too modern for an...