hat48lrc
05-16-2005, 08:19 PM
As I am preparing for a total remodel of the salon on my 48 LRC, which I believe will include installation of the Amtico Teak flooring, I am wondering about converting my engine room hatch to a power hatch. I am aware of this conversion being done on a few boats, but I really have no real grasp of the design. This hatch is approximately 2' x 4' and weighs in at about 40 lbs, it is a real PITA to lift out and with the installation of a teak floor would be real likely to end up scratching things up. Therefore I would like to convert this hatch to either electric or hydraulic.
Can anyone on the forum provide me with some of the mechanical requirements involved and maybe point me to where the necessary parts could be obtained. It appears that such an installation requires some sort of blind hinge as well as the addition of either a hydraulic ram or an electrical worm screw, etc?
Thanks,
Jim Alexander
Can anyone on the forum provide me with some of the mechanical requirements involved and maybe point me to where the necessary parts could be obtained. It appears that such an installation requires some sort of blind hinge as well as the addition of either a hydraulic ram or an electrical worm screw, etc?
Thanks,
Jim Alexander